echidnaEchidna D4HP Rocksaw Specification

Printed:24-Nov-2024 Specification may change without notice.

D4HP

D4HP Series Features

Automatic Blade Brake✔
Reversible Blade Spin Direction✔
Through-hub Water Distribution✔
Case drain required✔
Minimum Trench Width510 mm
Cutting Depth Loss170 mm
 cutting dimensions

Specification

Model


Saw ModelD4HP/NN
Excavator rangetonnes10 - 25
Blade Diameter Rangemm1100 - 2200
Mass (drive unit)kg240
Performance


Torque MaxNm1110
Speed Maxrpm820
Power MaxkW100
Input ratings


Flow Maxlpm230
Back Pressure Max.MPa0
Pressure MaxMPa30
Relief Valve Pressure (factory setting)MPa25
 


echidnaEchidna D4HP Rocksaw Specification
	

	Printed:24-Nov-2024 Specification may change without notice.
	
Recommended Flow Rates for D4HP






Rock Saw ModelDiamond Blade diameter /mm



1200
1400
1600
1800
2000
2200



Recommended Flow Rate (lpm



D4HP/NN
149 - 230
127 - 230
111 - 204
99 - 182
89 - 163
81 - 149



Recommended flow rate for each saw varies depending on the material to be cut.
			
The table above indicates the working range of the saw with the diamond and wood saw blades having the diameters indicated. 
		
This table does not apply to other blade types.
		
Contact your supplier for more specific recommendations for the material that you want to cut.



D4HP / 

 


echidnaEchidna D4HP Rocksaw Specification
	

	Printed:24-Nov-2024 Specification may change without notice.
	
Hydraulic Connections
D4HP / 

Power port1" bspp
Case Drain1/2" bspp
Signal Port(s)1/4" BSPP


 


echidnaEchidna D4HP Rocksaw Specification
	

	Printed:24-Nov-2024 Specification may change without notice.
	
Blade Mounting Dimensions
D4HP / 
	

	
Centre Spigot/ Hub Diameter * /mm
				Standard60

				
blades >1800mm (72") diameter100

	
	
	

	
Range available25-100

	
	
Blade Fastening Screws **
 
	
Screw SizeM12 x 25
		
	
	
PCD170mm
Qtyblades < = 1800mm (72")6

			
blades >  1800mm (72")12
	

	



Notes


*Blade Centre Spigot / Hub


Blade centre hubs are removable and can be replaced to provide for different blade centre holes. 

Special blade centre disks can be ordered to accommodate other blade dimensions. 

Changing the blade centring disk does not effect the location and dimensions of the blade fixing screws.


** Blade Screws


Use only high-tensile (10.9 or 12.9) screws for attaching the blade

 
 
Unused screw holes should be plugged with grub screws


For flush cutting, countersink screws are required and the countersinks in the blade must be sufficiently deep to avoid damage to the exposed face of the screws.

If the blade is too thin to accomodate the head of the screw, spacer plates are available and must be used.