echidnaEchidna D3S Rocksaw Specification

Printed:15-May-2024 Specification may change without notice.

D3S

D3S Series Features

Automatic Blade Brake✔
Reversible Blade Spin Direction✔
Through-hub Water Distributionoptional
Case drain required✘
Minimum Trench Width390 mm
Cutting Depth Loss175 mm
 cutting dimensions

Specification

metric
Model


Saw ModelD3S/BMD3S/SBD3S/NBD3S/RBD3S/SSB
Excavator rangetonnes5 - 75 - 106 - 1212 - 1512 - 15
Blade Diameter Rangemm1200 - 16001200 - 18001400 - 20001600 - 22001600 - 2200
Mass (drive unit)kg9696969696
Performance


Torque MaxNm390385390360360
Speed Maxrpm620620500380310
Power MaxkW2733343434
Input ratings


Flow Maxlpm100125125125125
Back Pressure Max.MPa1010101010
Pressure MaxMPa3030303030
Relief Valve Pressure (factory setting)MPa1919191919
 


echidnaEchidna D3S Rocksaw Specification


Printed:15-May-2024 Specification may change without notice.

Recommended Flow Rates for D3S




Rock Saw ModelDiamond Blade diameter /mm



1200
1400
1600
1800
2000
2200



Recommended Flow Rate (lpm



D3S/BM
99 - 100
85 - 100
74 - 100




D3S/SB
124 - 125
106 - 125
93 - 125
83 - 125




D3S/NB
116 - 125
103 - 125
93 - 125




D3S/RB
117 - 125
107 - 125




D3S/SSB



Recommended flow rate for each saw varies depending on the material to be cut.

The table above indicates the working range of the saw with the diamond and wood saw blades having the diameters indicated.

This table does not apply to other blade types.

Contact your supplier for more specific recommendations for the material that you want to cut.



D3S / 

 


echidnaEchidna D3S Rocksaw Specification


Printed:15-May-2024 Specification may change without notice.

Hydraulic Connections
D3S / 

Power port3/4" bspp
Case DrainNA
Signal Port(s)1/4" BSPP


 


echidnaEchidna D3S Rocksaw Specification


Printed:15-May-2024 Specification may change without notice.

Blade Mounting Dimensions
D3S / 



Centre Spigot/ Hub Diameter * /mm
Standard60


blades >1800mm (72") diameter100


Range available25-100


Blade Fastening Screws **


Screw SizeM12 x 25


PCD170mm
Qtyblades < = 1800mm (72")6


blades > 1800mm (72")12
 




Notes


*Blade Centre Spigot / Hub


Blade centre hubs are removable and can be replaced to provide for different blade centre holes. 

Special blade centre disks can be ordered to accommodate other blade dimensions. 

Changing the blade centring disk does not effect the location and dimensions of the blade fixing screws.


** Blade Screws


Use only high-tensile (10.9 or 12.9) screws for attaching the blade


Unused screw holes should be plugged with grub screws


For flush cutting, countersink screws are required and the countersinks in the blade must be sufficiently deep to avoid damage to the exposed face of the screws.

If the blade is too thin to accomodate the head of the screw, spacer plates are available and must be used.